All posts by chainnephew9
Speak "Yes" To These 5 Seat Keys Replacement Tips
Seat Alhambra Key Problems
Seat's family MPV jumbo is one of the best in the market in terms of keeping resales value. And with a brand new model now available, it's even better.
There are a number of reasons why the key fob might not function properly including dead coin battery, damage to the receiver module, water problems or signal interference. This article will guide you through the steps necessary to get it working.
Water Damage
If your seat alhambra key fob can withstand the wash cycle or a bath in the pool or ocean then it's probably equipped with an amazing waterproof chip but do not make it a habit as exposure to excessive water increases the risk of the key fob getting damaged. If the key fob ceases to working after exposure to clean water from the tap or rain, just take out the battery, wipe the electronic component with paper towel and allow it to dry completely before putting it back into. If the key fob has been exposed to soapy or salty water it is recommended that you clean the chip with isopropyl or electronic cleaner.
Faulty Receiver Module
If the key fob will not lock or unlock after having replaced the battery for the button It is possible that the receiver module is suffering from a fault. The good thing is that this is an easy and cost-effective fix. You can simply disconnect the battery for a few minutes (first remove the negative cable then press the horn button several times) to eliminate any remaining electric current, then reconnect it in reverse order e.g. Positive first followed by negative.
ESP Warning Light If the ESP warning symbol flashes this is normal and indicates that the vehicle is driving through terrain in which the traction between the road surface and tyres isn't ideal, such as gravel, snow or a lot of surface water. If the ESP light is constantly flashing, it is a sign there is a flaw in the system. It can be detected with a iCarsoft i908 seat OBD code reader kit. It will provide the full description of the problem.
Dead Coin Battery
A dead coin battery is among the most common reasons for the seat alhambra keys to stop working. The key fob is powered by a tiny button-cell battery. It should be replaced with a brand new one with identical in size, voltage and specifications as the original. If you're replacing the battery ensure that you remove all metal clips from the back of the key fob and make sure the contacts are free of corrosion.
If the key fob was exposed to water (such as rain or soapy tap water) it is recommended that you remove and clean the chip with an electronic cleaner or isopropyl ethanol before installing a brand new battery. The chip is sensitive to moisture and may be permanently damaged. If the key fob still does not work after replacing the battery it could be necessary to replace the key fob.
Faulty Receiver Module
If your key fob has stopped working after you replaced the battery and it did not help, or if it just stopped working without notice the receiver module might have developed a fault. The receiver module is responsible to receive the radio frequency signals that are sent by the remote key fob and transform them into electrical commands that are then utilized by other modules in your car.
If TheKeyLab has developed a fault and is unable to respond to any of the commands issued by your remote key fob. In this instance you'll be required to visit a service for reprogramming of the key fob, and also a new receiver module.
The key fob has rubber seals that stop water from getting into the chip inside. If you dip the key fob in soapy or salty water, it could damage the chip. If your key fob won't work, you can try cleaning the chip with isopropyl or an electronic cleaner.
If the keys have been paired, but the receiver module is malfunctioning You can try to restart all the electronics that are on board by disconnecting the battery at 12 volts for couple of minutes. Then, reconnect the battery in reverse order (negative cable first, then positive). This will reset all the on-board electronics and should restore their functionality.
Faulty Electronic Chip
The key fob has a small electronic chip which transmits a signal the receiver module whenever the key is used. If the signal doesn't match that stored by the car, the immobilizer will disable the engine and stop the vehicle from beginning. If the key fob isn't functioning and you can't reprogram it this could be due to a defective chip.
The chip inside the key fob may need to be replaced to make it work again. This can be accomplished by removing the key fob from its housing, and then using pins or needles to make contact with each metal retaining clip. If these clips are damaged or broken, you will need to replace them to allow the remote control to work. Make sure that any replacement batteries have the same voltage, size and specifications as the original one.
Seat Alhambra, a popular and well-designed car, can be troublesome due to specific parts or equipment. For instance there are owners who have had problems with the automatic climate control system, which could malfunction and cause problems in a specific setting. The infotainment systems can also fail and cause freezing of the screens.
